Powered by nature's fresh mint scent · No poison baits · Free shipping over $75 📞 1-800-474-5115

How to apply Mint Repel

A chip brush and twenty minutes. No licensing, no respirator, no special tools. Below is every place worth treating, with what to do, what to think about, and what to keep the gel away from.

The basics

Four steps, every time

01

Look for the gaps

Walk the foundation, garage, basement and attic. Pests use gaps around pipes, wires, vents and door corners.

02

Prep

Brush off dust and cobwebs. The surface should be dry. No cleaners needed.

03

Brush it on

Use a chip brush or small roller. Build a continuous band or ¼-inch collar with no gaps.

04

Let it set

Dries clear in about an hour and leaves a fresh mint scent. Reseal and store upright.

Where to apply it

8 places worth treating

Pick the one you are working on. Each opens its own guide with a photo, a walkthrough video, the steps, what to keep in mind and what to keep the gel away from.

01 Foundation & sill plate The line where the wooden framing sits on the concrete or block foundation, inside and out, all the way around the building. View the guide → 02 Pipe, wire & vent entries Every hole drilled through the wall: water and gas lines, air-conditioner line sets, electrical and cable service, dryer and bath vents, hose bibs. View the guide → 03 Garage door corners & thresholds The bottom two corners of the overhead door, the base of both jambs, the side-door threshold and the wall between the garage and the house. View the guide → 04 Crawl space & basement rim joists Rim joists, the top of the foundation wall, vent frames, the access hatch, and sump and utility openings. View the guide → 05 Attic edges, soffits & roofline Soffit and fascia joints, gable vents, roof-line gaps, and the points where wiring or plumbing vents pass into the attic. View the guide → 06 Decks, porches & stairs The ledger board against the house, joist ends, stair stringers, post bases and lattice skirting. View the guide → 07 Sheds & outbuildings Shed sill plates, door thresholds, floor edges, and the bases of stored mowers, bikes and equipment. View the guide → 08 Under sinks, laundry & utility rooms The cabinet penetrations under kitchen and bathroom sinks, behind the dishwasher and washing machine, and around the water heater and furnace lines. View the guide →
Technical data

Specifications

FormHigh-viscosity clear gel with fresh mint scent
ApplicationBrush or roller
Dry to touchAbout 45–60 minutes
FinishNon-staining, dries clear
UseIndoor & outdoor
Compatible surfacesWood, concrete, masonry, metal, PVC, vinyl, painted trim
Coverage1 quart treats roughly 150 sq ft of entry points; 1 gallon roughly 600 sq ft
StorageStore upright, 40°F–90°F, tightly sealed
PrecautionsKeep out of reach of children. Read the label before use.
Made inUSA
Precautions. Keep out of reach of children. Avoid contact with eyes. Do not apply to surfaces above 400°F. Read the label before use. Store upright between 40°F and 90°F and reseal tightly.